Preparation for the sowing season of John Deere tractors

Before starting sowing work, it is important to prepare equipment in advance. For such maintenance and repair, LLC "Universal Service Ukraine" provides spare parts for John Deere tractors in Odessa. Seasonal maintenance is included in the preparatory set of procedures. Simplifying it will help to observe the rules for the storage of equipment and proper operation. Annual maintenance is also an important point.

We are preparing for the sowing season

Preparatory work for the John Deere tractor begins with the removal of the heater located on the hood of the machine. It is also necessary to turn on the engine oil radiator, which is turned off for the winter.

The condition of the batteries is being checked. After measuring the density, this indicator is adjusted to the summer level. The cooling system is checked for scale and cleaned:

1. liquid drains;
2. the container is filled with a soda-based descaling agent;
3. diesel engine starts and works with such a filler for about 10 hours.

After the cleaning procedure, the engine is stopped, the system is emptied and thoroughly flushed with liquid (ordinary water will do).

To complete the preparatory work, the equipment is refueled, and an additional check of the cooling systems is performed. It is also necessary to check the electrics, including the insulating shell, the voltage level and the charging current of the generator.

Maintenance

Regular inspection and maintenance of equipment includes cleaning of filter systems and centrifuges. Oil clogs greatly reduce the operational characteristics of these units and the entire unit. The John Deere fuel filter is replaced in two stages. After the fine filter replacement procedure, fuel is pumped into the main part of the unit. Timely replacement of filtering systems will help to maintain the correct operation of all components of the unit, as well as reduce fuel consumption. If this is not done, diesel consumption, on the contrary, increases, and this indicator can reach 5% for each filter.

The centrifugal oil filter in this machine must be disassembled and cleaned. The process takes place in several stages:

1. it is necessary to remove the cap and take out the rotary cup;
2. wash parts in diesel;
3. the body and components are assembled back.

After installation, the glass should rotate freely. In this case, it will fully cope with oil cleaning. With the last touch, the cap is put in place.

Cleaning the filters

The filtration system is an important part of the tractor that affects the quality of work and fuel consumption. Therefore, it is necessary to pay special attention to it during preparatory work. The air filter in John Deere brand equipment consists of several cassettes that perform stepwise filtration:

1. the first one of low density catches large particles of garbage;
2. the second has an average density;
3. the third performs the finest cleaning.

For maintenance, it is necessary to disassemble the system: unscrew the fastening screws, remove the pan and drain the oil. After that, the elements must be washed in diesel fuel. The assembly of the air filter is made from the smallest cassette to the largest one. The bath is installed in a tray and filled with oil.

The oil filter is quite easy to clean. The system is disassembled into components. The filtering parts must be removed from the grid. To eliminate contamination, it is enough to wash the parts with diesel fuel and brush them. Next, the filter is assembled in the working position.

In Odessa, you can buy the necessary components for tractors of this brand at Universal Service Ukraine LLC. Our specialists will help you choose suitable parts and purchase them profitably. You can use the following contact details to contact the project consultants:

1. address: Odessa, Lyustdorfskaya dor. 92/94, 509;
2. telephone: 0-800-400-600.

With high-quality components, the procedure for preparing the tractor for sowing will be quick and easy, and fuel consumption will be minimal.