236
If you notice that antifreeze is leaking, follow the following tips to avoid major problems. The radiator cap is a massive problem in all Chevrolet Aveo models, despite their short service life.
It is possible to consider two options. First, brew a leak. This will help you avoid buying for a while or buy a new radiator.
Usually, the leak is filled with a sealant, since it is impossible to do this with the help of aluminum. This method will not last long and soon the leak will make itself known again.
You can also find a high-quality radiator on the site http://www.luzar.ru/catalogue/radiatory/tagaz/?category=, which will be much cheaper in cost.
Professionals advise to change the cap of the antifreeze, since when it is cold, condensate forms on the cap of the barrel, and when it freezes due to pressure, the radiator breaks.
If you decide to buy a radiator, it is best to consider Korean companies. As a rule, masters advise not to save money and buy the original.
How to replace?
Open the cap of the antifreeze tank, and then unscrew the drain plug at the bottom with the help of a ten-point wrench. Next, pour out all the liquid.
Then we will remove the heating hose. I previously removed the collar with pliers. After that, the inlet and outlet tubes should be removed with pliers, and the clamp should also be removed in advance.
Next, remove the steam drain hose using pliers. Having previously unscrewed two nuts on the sides, we remove the flushing tank. After removing the tank, remove the clamp and remove the drain and liquid hoses, as well as the steam drain hose from the tank. Then we unscrew all the remaining bolts.
In order to disconnect the sensor from below on the radiator, which is located on the fan, you need to press the side latch with a screwdriver. It is considered the most difficult stage during disassembly.
We move the radiator, tilting it to the side of the engine, and remove the upper brackets. We carefully select the radiator with both hands.
What to do next? It is possible to wash the radiator and eliminate worn pipes and change them to new pipes. It is best to install a completely new radiator and forget about this problem. Prices for a new original radiator are from 4 thousand rubles and higher. The radiator is installed in exactly the same way as it was done before. Then, pour in good quality antifreeze. We start the car, let it warm up, and check the level of antifreeze, if necessary, top up to the required level. It is recommended to use red Motul antifreeze.
